Powerline 2000 Connection Kit

LED not on: No power supply

LED lights up white: Everything is OK. The Powerline connection is working.

LED flashes white: The Powerline adapter is pairing with the device. Please wait approx. 15 seconds.

LED flashes white slowly: Powerline adapter is in low power mode. An Ethernet cable must be connected for pairing.

LED flashes red: No connection to the Powerline adapter

LED lights up red: Poor connection to the Powerline adapter

The actual data rate of the Powerline adapter will be greatly influenced by the conditions in your home or apartment. In Swisscom tests, data rates of between 150 and 300 Mbit/s were measured for the new Powerline adapters. This bandwidth is suitable for most applications, including multi-stream TV.

The Powerline 2000 combination you require depends on the number of Swisscom TV-Boxes you want to connect:

• 1 TV-Box: One Powerline Connection Kit 2000 (2 adapters)
• 2 TV-Boxes: One Powerline Connection Kit 2000 and one Powerline 2000 Connection adapter (3 adapters)
• 3 TV-Boxes: One Powerline Connection Kit 2000 and two Powerline 2000 Connection adapters (4 adapters)
  

1. Plug the new adapter directly into any wall power socket next to the device you want to connect. Connect the adapter to any device that can access the Internet (e.g. PC, Internet-TVBox or game console) using the provided network cable.
   
2. Hold down the plus (+) button on the adapter to which the DSL/fibre router is also connected for two seconds.
3. The LED starts to flash white. If it doesn't, repeat this step.
4. Hold down the plus (+) button on the other adapter.
5. The LED starts to flash white. If it doesn't, repeat this step.
6. The LEDs on the two adapters will show a steady white light when successfully paired. If pairing is unsuccessful, try again. Reset the two adapters before pairing.